Why does my Zebra printer Say error?

Why does my Zebra printer Say error?

The first cause of this issue is due to an incorrect setting in the printer’s driver. To correct this problem, please do the following: Open the Start Menu and select “Devices and Printers”, “Printers”, or “Printers and Faxes”. Right-click on the Zebra Eltron printer icon and select “Printing Preferences”.

How do I set up my zm400 printer?

With the printer powered on and at an idle state (no errors on the LCD screen), enter the menu by pressing the Setup/Exit button and using the + button to scroll to the entry called ‘List Setup’. Next, press the ‘Select’ button (check mark) and press the + button. The printer should then print a configuration page.

How do I reset my Zebra label printer?

Hold down the forward feed button on the front panel. The indicator light will start a flash sequence: 1, 1-2, 1-2-3, and so on. When it flashes four times, release it. This resets the printer to factory defaults.

How do I get my Zebra printer out of error state?

Right-click on the driver and click Remove device.

1. Restart your PC.
2. Once the PC is ready, reconnect the USB while the printer is on, then let the plug and play reinstall the driver.

How do you set up a label printer?

Configure the label printer

1. Go to Devices and Printers on your computer.
2. Right-click the label printer and select Printer Properties.
3. Go to the Advanced tab and set the Print directly from printer option.
4. Click Apply.
5. Click the Printing Defaults icon.
6. Go to the Options tab.
7. Set Darkness to 15.

How do I print a configuration page from my zm400?

Another quick and easy way to print a configuration page from your ZM400 is by powering the printer off with the switch on the back of the printer. Press and hold the ‘Cancel’ button while switching the power back on.

How to troubleshoot zebra zm400 printer problems?

This when the technicians go through a few Zebra ZM400 Troubleshooting steps to get to the root of what may be the issue. First thing is to visually inspect the printer. Look for cleanliness or points of wear and prolonged use as these are the leading causes of faults.

What does the error light mean on my Zebra printer?

Causes: The printhead was replaced with one that is not a genuine Zebra™ printhead. Remedy: Install a genuine Zebra printhead. Description: The printer stops; the ERROR light flashes. Causes: In thermal transfer mode, ribbon is not loaded or incorrectly loaded.

What does the error light on the printhead mean?

Causes: The printhead is not fully closed. The head open sensor is not working properly. Remedy: Replace the sensor. Description: The ERROR light flashes. Causes: The printhead has a faulty thermistor. Remedy: Replace the printhead.