How do you disassemble a Kimber pro carry II?

Push the Slide Lock Lever from the Opposite Side of the Gun and pull it out the Front. Pull the Slide off the Front of the Gun Frame. Place the Slide Upside Down and Remove the Guide Rod, Recoil Spring and Barrel. Kimber Pro Carry II Completed disassembly.

Do you need a wrench to disassemble a Kimber 1911?

Disassembly of a Kimber 1911 with a Barrel Bushing Disassembly Tools. You will likely need a Barrel Bushing Wrench for this procedure. There are some 1911 Models that will allow you to do this with your fingers, but my experience with my Kimber is that a wrench is definitely needed!

What kind of barrel does Kimber pro carry II have?

1911 disassembly video is at the end of this article. The Kimber Pro Carry II is a 1911 with a 4″ “bull” barrel. The bull barrel is a different design form a standard 1911 in that it does not use a barrel bushing to hold it firmly in the slide.

What are the dimensions of the Kimber take down tool?

Kimber Take Down Tool Update: I recently discovered the this tool is very hard to find. A lot of places that carry it are out of stock, so here are the dimensions so you can make one out of a paper clip. The long side is about 2 3/4″ inches and the more important dimension is the short side, which is 1/2″.

Can You disassemble a Kimber 1911 with a bull barrel?

This 1911 disassembly reassembly field strip procedure will not work for a Kimber model with a “bull barrel”. Most of the 4″ 1911 Models use a different design to lock the barrel to the slide. If you have the 4″ model, see my article Cleaning a Kimber 1911 Pro Carry. or Kimber Pro Carry II Disassembly.

How do I remove the hard drive from the N550?

The N550 comes with a 14.8v, 4000mah Li-polymer battery, Asus P/N: C41-N550. Remove four screws securing the hard drive module. Disconnect SATA cable from the motherboard. Slide the hard drive module to the left. The hard drive can be removed.

How do I replace the battery in my N550?